Balboa BP7 Spa Control 4.0kW Flow Thru Heater G6406

With 7 relays, the BP7 has 32 different setups and can power aspa with 1-3 pumps, including Microsilk systems. Can also replace any Balboa BPSystem* while using the existing topside that is already installed on the spa.Will replace any Balboa or other brand’s non-low flow system* when you match itwith any TP or SpaTouch topside panel. 

G6406 BP7 Programming and Topside Configuration click  HERE

Features:

• Supports all TP and SpaTouch topsides
• Supports all BP ancillary products (ControlMySpa, BBA, CZ, and Status Pro)
• Plug-N-Click Heater
• WiFi Ready (Not included- accessory WiFi Unit) 50350-07

Kit Includes:

• G4361 - Balboa BP7 System with 4.0kW Heater
• 55676-09 - Balboa TP600 Panel, Less Overlay -Measurements: W=7.1" (18.03cm) , H=3.5" (8.89cm)
• 12762 - TP600 Panel Overlay (6-Button, Oval)
• 25098 - Wire Assembly, 8ft for spa light
• 15380 - Panel Bezel (Adapter Plate)

-CAN REPLACE ANY BP BALBOA SYSTEM* - While using the existing topside that is already installed on the spa.

-CAN REPLACE ANY BALBOA VS OR EL SYSTEM* - When you match it with any TP or SpaTouch™ topside panel.

• *Both the Circ pump and Ozone can be converted to 120V, however, they will be the same voltage after conversion. (Both 120V or both 240V.)
• *If a 24-hour circulation pump is being installed, it must have no less than a 23 GPM flow. Laing, Grundfos, or Waterway Tiny Might pumps do not perform at this rate and cannot be used.